Journal of Science and Technology of Composites

Developing homotopy perturbation method to investigate the nonlinear vibration of a Porous FG-Beam subjected to the external excitation

Document Type : Research Paper

Authors

1 Department of Mechanical Engineering, Azarbaijan Shahid Madani University, Tabriz, Iran

2 Department of Mechanical Engineering, University of Tabriz, Tabriz, Iran

10.22068/jstc.2020.116889.1604

Abstract

In this paper large amplitude vibration analysis of a porous FG-beam rested on a Winkler foundation and subjected to a harmonic loading is analytically investigated. The material properties of the porous FG beam are assumed to vary continuously according to a simple power law. Employing Von Karman’s geometric nonlinearity, implementing the Galerkin’s method and assuming doubly clamped immovable end boundary conditions, the governing nonlinear partial differential equation is reduced to a nonlinear ODE. Because of the large coefficient of the nonlinear term and due to existence of the external harmonic loading effect, none of the traditional perturbation methods leads to a valid solution. So, in order to solve this nonlinear nonhomogenous equation, the modified homotopy perturbation method is developed and it is called developed homotopy perturbation method (DHPM). For validating, the time response results obtained by DHPM and numerical methods are compared for various values of excitation amplitudes and frequencies. The increasing of nonlinear frequency obtained by DHPM with those of existence literature revealed a good agreement with a desired accuracy. Finally, the frequency response curves are presented for different values of volume fraction exponent together with porous volume fraction and the effects of nonlinearities on the frequency response curves are discussed in detail.

Keywords

Main Subjects

References
[1]Ghazi, R., Payghaneh, G. and  Shahgholi, M., “Resonance Analysis and Free Nonlinear Vibrations of a Nanocomposite with Internal Damping,” In Persian, Modares Mechanical Engineering, Vol. 17, No. 12, pp. 98-104, 2018.
[2]Zhu, J., Lai, Z., Yin, Z., Jeon, J. and  Lee, S., “Fabrication of Zro2–Nicr Functionally Graded Material by Powder Metallurgy,” Materials chemistry and physics, Vol. 68, No. 1-3, pp. 130-135, 2001.
[3]Aqida, S., Ghazali, M. and  Hashim, J., “Effect of Porosity on Mechanical Properties of Metal Matrix Composite: An Overview,” Jurnal Teknologi, Vol. 40, No. 1, pp. 17-32, 2004.
[4]Kim, H. S., Yang, Y., Koh, J. T., Lee, K. K., Lee, D. J., Lee, K. M. and  Park, S. W., “Fabrication and Characterization of Functionally Graded Nano‐Micro Porous Titanium Surface by Anodizing,” Journal of Biomedical Materials Research Part B: Applied Biomaterials: An Official Journal of The Society for Biomaterials, The Japanese Society for Biomaterials, and The Australian Society for Biomaterials and the Korean Society for Biomaterials, Vol. 88, No. 2, pp. 427-435, 2009.
[5]Wattanasakulpong, N., Prusty, B. G., Kelly, D. W. and  Hoffman, M., “Free Vibration Analysis of Layered Functionally Graded Beams with Experimental Validation,” Materials & Design (1980-2015), Vol. 36, pp. 182-190, 2012.
[6]Mehrdad, S. M. and  Elahi, M., “A New Model to Estimate the Young’s Modulus of Polymer Concrete Using Micromechanical Relations,” In Persian, Modares Mechanical Engineering, Vol. 12, No. 2, pp. 153-162, 2012.
[7]Wattanasakulpong, N. and  Chaikittiratana, A., “Flexural Vibration of Imperfect Functionally Graded Beams Based on Timoshenko Beam Theory: Chebyshev Collocation Method,” Meccanica, Vol. 50, No. 5, pp. 1331-1342, 2015.
[8]Atmane, H. A., Tounsi, A. and  Bernard, F., “Effect of Thickness Stretching and Porosity on Mechanical Response of a Functionally Graded Beams Resting on Elastic Foundations,” International Journal of Mechanics and Materials in Design, Vol. 13, No. 1, pp. 71-84, 2017.
[9]Ebrahimi, F. and  Mokhtari, M., “Transverse Vibration Analysis of Rotating Porous Beam with Functionally Graded Microstructure Using the Differential Transform Method,” Journal of the Brazilian Society of Mechanical Sciences and Engineering, Vol. 37, No. 4, pp. 1435-1444, 2015.
[10]Ebrahimi, F., Ghasemi, F. and  Salari, E., “Investigating Thermal Effects on Vibration Behavior of Temperature-Dependent Compositionally Graded Euler Beams with Porosities,” Meccanica, Vol. 51, No. 1, pp. 223-249, 2016.
[11]Shafiei, N., Mousavi, A. and  Ghadiri, M., “On Size-Dependent Nonlinear Vibration of Porous and Imperfect Functionally Graded Tapered Microbeams,” International Journal of Engineering Science, Vol. 106, pp. 42-56, 2016.
[12]Pourashraf, S. T. and  Ansari, R., “Nonlinear Forced Vibration Analysis of Functionally Graded Nanobeams in Thermal Environments by Considering Surface Stress and Nonlocal Effects,” In Persian, Modares Mechanical Engineering, Vol. 14, No. 16, 2015.
[13]Rahmani, B. and  Gholami, F., “Robust Vibration Control of a Functionally Graded Cracked Beam,” In Persian, Journal of Science and Technology of Composites, Vol. 2, No. 1, pp. 41–52, 2015.
[14]Ke, L.-L., Yang, J. and  Kitipornchai, S., “An Analytical Study on the Nonlinear Vibration of Functionally Graded Beams,” Meccanica, Vol. 45, No. 6, pp. 743-752, 2010.
[15]Şimşek, M. and  Kocatürk, T., “Free and Forced Vibration of a Functionally Graded Beam Subjected to a Concentrated Moving Harmonic Load,” Composite Structures, Vol. 90, No. 4, pp. 465-473, 2009.
[16]Kanani, A., Niknam, H., Ohadi, A. and  Aghdam, M., “Effect of Nonlinear Elastic Foundation on Large Amplitude Free and Forced Vibration of Functionally Graded Beam,” Composite Structures, Vol. 115, pp. 60-68, 2014.
[17]He, J.-H., “A New Perturbation Technique Which Is Also Valid for Large Parameters,” Journal of Sound and Vibration, Vol. 5, No. 229, pp. 1257-1263, 2000.
[18]Rezaee, M. and  Minaei, M., “A Theoretical and Experimental Investigation on Large Amplitude Free Vibration Behavior of a Pretensioned Beam with Clamped–Clamped Ends Using Modified Homotopy Perturbation Method,” Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Vol. 230, No. 10, pp. 1615-1625, 2016.
[19]Emam, S. A. and  Nayfeh, A. H., “Postbuckling and Free Vibrations of Composite Beams,” Composite Structures, Vol. 88, No. 4, pp. 636-642, 2009.
[20]Fallah, A. and  Aghdam, M., “Nonlinear Free Vibration and Post-Buckling Analysis of Functionally Graded Beams on Nonlinear Elastic Foundation,” European Journal of Mechanics-A/Solids, Vol. 30, No. 4, pp. 571-583, 2011.
[21]Azadi, M., “Free and Forced Vibration Analysis of Fg Beam Considering Temperature Dependency of Material Properties,” Journal of Mechanical Science and Technology, Vol. 25, No. 1, pp. 69-80, 2011.
 
Journal of Science and Technology of Composites
Volume 7, Issue 2
September 2020
Pages 907-916
Files
Share
How to cite
Statistics