Journal of Science and Technology of Composites

Journal of Science and Technology of Composites

Design and measurement of the first Iranian sandwich Radome panel for C – band weather radar application

Document Type : Research Paper

Authors
Majid Mokhtari 1
Farid Nazari 2
Madhid Taherkhani 2
Hadi Aliakbarian 2
Soheil Radiom 1
1 Department of Mechanical Engineering,, ISRC, Space research center, Tehran, Iran
2 Department of Electrical Engineering, K.N. Toosi University of technology, Tehran, Iran
10.22068/jstc.2018.79074.1412
Abstract
The antenna radomes have been developed to protect antenna systems against harsh environmental conditions, with the most electromagnetic transparency. The wind speed of 220 km/h, -40 to 65 degrees Celsius of temperature deviations, 90 % of relative humidity (RH), protection for UV radiation and finally, one way electromagnetic loss of less than 0.3 dB along with the maximum difference between vertical and horizontal polarizations of 0.05 dB are the main requirements of the weather radar radomes. In this paper, engineering design and experimental studies of some samples of the first sandwich panel radome of C – band weather radar, including manufacturing process, buckling and electromagnetic experimental tests, have been briefly explained. In the material selection process the environmental requirement have been considered. Evaluation of mechanical stability of the radome under wind pressure has been studied in experimental buckle tests and finite element analysis with ABAQUS 6.12. Insertion loss test in anechoic chamber was done to evaluate the transparency of the sandwich panel samples. Buckling tests show that the manufactured sandwich panel can oppose safely with 190 N buckling load. According to the electromagnetic insertion loss tests of the manufactured panels show that the one way insertion loss and the difference between the vertical and horizontal polarizations, are in the range of the required limitations.
Keywords
Radome
Weather radar
Sandwich panel
Buckling
Insertion loss

Subjects

 
[1] Oliner, A.A. Jackson, D.R. Volakis, J.L., "Antenna engineering handbook", McGraw Hill, 2007
[2] Europe, S. T. "Installation and operation manual for sea tel model 14600-50 redundant C-band TX/RX antennas", 2007.
[3]  Shepherd, G.W. Searson, J. Pallot, A. Collier, C.G., "The performance of a C-Band weather radar during a line convection event,” Meteorological Applications. 1995.
[4] Nakagawa, K. Hanado, H. Satoh, S. Takahashi, N. Iguchi, T. Fukutani, K., "Development of a new C-band bistatic polarimetric radar and observation of typhoon events", paper presented at 31st Conference on Radar Meteorology ,Am. Meteorol. Soc., Seattle, Wash, 2007
[5] Scott M. H., "Radiation pattern calculation for missile radomes in the near field of an antenna, Naval postgraduate School Monterey, California, 1996
[6] Mokhtari, M. Shahravi, M., "Numerical and experimental analysis of dynamical behavior of composite T-joint with step wise graded adhesive zone based on functional behavior model",Journal of Science and Technology of Composites, Vol 4, No 3, pp. 319-326, 2017. (In Persian)
[7] Ebadi-Rajoli, J. Mokhtari, M., "Comparison of numerical analysis methods for progressive damage analysis in composite bolted joints and suggestion of new method for bolted joints analysis", Journal of Science and Technology of Composites, Vol. 2, No. 2, pp. 63-70, 2015. (In Persian)
[8] Khalili, S.M.R. Mokhtari, M., "Numerical Study of Adhesive Single-Lap Joints with Composite Adherends Subjected to Combined Tension–Torsion Loads", The Journal of Adhesion, Vol. 91,No 3, pp. 214-234, 2014.
[9] IRIMO, Available: http://www.irimo.ir, 2017.
[10] Li, P. LI, N. XU, W. Song, L. "Phase Compensation of Composite Material Radomes Based on the Radiation Pattern" Chin. J. Mech. Eng., Vol. 30, p. 587-594, 2017.
[11] Kozakoff, D. J., "Analysis of Radome-Enclosed Antennas", Artech House, 2010.
[12] Cheng, D. K., "Field and wave electromagnetics ,”Proc. Int. Conf. on Power System Reliability., Singapore, 1999.
[13] Knott, E. F., "Radar Cross Section Measurements", SciTech Publishing, 1985.
[14] Mokhtari, M., Salari, M. Abdoli, H., "Design and Manufacturing of Engineering Model of GEO Satellite Ku Band Antenna-Structual Design Reportation," Shahid Ghandi Center of Research, Tehran, 2014 (In Persian).
[15]Reno, Nevada radar dome failure, 2017. Available: http://cimss.ssec.wisc.edu /goes/blog/archives/1581
[16]Radar Sampled by Thunderstorm,” Roger Edwards, Storm Prediction Center, Available: http://www .spc.noaa.gov /coolimg/rmuncher.ht2017.
[17]         VARTM-Rresin infusion process ,”. Available : http ://www .compositesuniversal . com/ manufacturing-6.html.. 2017.
 
 
Journal of Science and Technology of Composites
Volume 6, Issue 2
Summer 2019
Pages 234-241